Page 1 of 1

D-WARP Still for entire clip

PostPosted: Wed Aug 23, 2017 5:08 pm
by jack0rlando
It would be great if I could choose the individual frame where D-WARP is calculated and apply that to the whole clip.

Right now D-WARP takes an average for the still setting over multiple frames which doesn't help when people walk through seams. When prioritise space and prioritise time give flickery results it would be fantastic if you could apply the same warp to an entire section based on one D-WARP calculation from an specific individual frame.

Does that make sense?