Page 1 of 1

Nodal Point - Nodal Ninja RS 2 ring mount

PostPosted: Sun Dec 11, 2016 11:13 pm
by Marc Lucas
Hi

Just got the Nodal Ninja RS 2 and using the ring mount adaptor for the Sigma 8mm fisheye. The only way to achieve the Nodal point is to position the camera so far back that the side of the bracket can be seen in lens. Is this going to cause problems with the stitching or will the overlap (taking 3 images with a 180degrees lens) sort things out?

Re: Nodal Point - Nodal Ninja RS 2 ring mount

PostPosted: Mon Dec 12, 2016 12:51 am
by Destiny
Hi.. That does not sound right.. I would suggest you check in with Bill Bailey @ Nodal Ninja and ask him for some suggestions on this.. He will respond very quickly....

Destiny...

Re: Nodal Point - Nodal Ninja RS 2 ring mount

PostPosted: Mon Dec 12, 2016 1:07 am
by Marc Lucas
I'm also going to contact the vendor and see what they suggest also. Do you just send a contact email to Bill through the site?

Re: Nodal Point - Nodal Ninja RS 2 ring mount

PostPosted: Mon Dec 12, 2016 2:11 am
by Destiny
Yes, I think so. He will read your message fairly quickly but don't forget they are in the US...

Destiny..

Marc Lucas wrote:I'm also going to contact the vendor and see what they suggest also. Do you just send a contact email to Bill through the site?

Re: Nodal Point - Nodal Ninja RS 2 ring mount

PostPosted: Thu May 11, 2017 3:15 pm
by jimbee
Marc Lucas wrote:I'm also going to contact the vendor and see what they suggest also. Do you just send a contact email to Bill through the site?


Good if you can post here what you find out.