Page 1 of 1

PTP start time grows with increasing memory

PostPosted: Sat Aug 11, 2018 6:05 am
by roetty
Hello,
I use PTP since 2015 and have now discovered an interesting problem. I have upgraded my workstation from 24GB of memory to 72GB and since this change the program start of PTP take over 60 seconds! If I remove the memory again, PTP starts again as usual in about 5-10 seconds. Then re-installed the memory and long start time.

How can I solve this?

Kind regards
Michael

Re: PTP start time grows with increasing memory

PostPosted: Tue Aug 14, 2018 9:34 pm
by roetty
Hello? Admins and Developer? What about my problem?

Re: PTP start time grows with increasing memory

PostPosted: Fri Aug 17, 2018 12:41 pm
by benji33
Hello,
There is an issue with large amount of RAM with Panotour. This issue is not identified yet. Sorry about that.