I am slowing updating all my tours from 1.8 to 2.2 and I have run into a problem with “custom view”.
If I open a PTP 1.8 tour in 2.2, and select a hotspot that had “load spot view” then the Action parameter window is frozen, with a grey bar down the middle.
Action Parameters frozen.JPG [ 40.77 KiB | Viewed 224 times ]
I can unfreeze the “Action Parameters” window by changing the custom view, to default view and the back again to custom view.
But by doing that I lose the information of where the customer view/ spot view was set.
Is there any way to update a tour from 1.8 to 2.2 while keeping the custom view/ spot view?