Page 1 of 1

show 180 degrees

PostPosted: Sun Aug 12, 2018 12:47 pm
by ken1127
Hello, I want to ask
a 360 degree view
I only hope to show 180 degrees.
In panoture software
How should I set it?
Thank you

Re: show 180 degrees

PostPosted: Fri Aug 17, 2018 12:29 pm
by benji33
180° horizontally ?
There is a trick. Change the horizontal value to 359°
Then use the crop tool into the hotspot editor and define the 180° portion.
Then Change the horizontal value of the scene to 360°

Re: show 180 degrees

PostPosted: Tue Aug 28, 2018 7:18 am
by ken1127
Where is the setting horizontal ?
On the “ptp” software?
Please give more guidance

Re: show 180 degrees

PostPosted: Tue Aug 28, 2018 9:14 am
by benji33
Select the scene.
Into the right part of the software You can setup the horizontal, vertical and vertical offset values of the view/projection.
http://www.kolor.com/wiki-en/action/vie ... Projection
Do the 359° trick here.

Once done the crop tool is into the Hotspot editor into the bottom left of the screen.
http://www.kolor.com/wiki-en/action/vie ... ditor#Crop