Page 1 of 1

Help with HP Printer

PostPosted: Sat Jul 07, 2018 4:10 am
by minhtuchael033
Hello Everyone,

I have an HP 750C DesignJet which is a pretty horrible printer by modern standards but it is OK for some fun.

It was working fine. I stopped using it for a few months and now it is prints with noticeable banding. The odd thing is that if I print a block of a solid colour then there are no bands but if I print a photo there are. I have calibarated it and gone through all the steps in the manual without any success.

Is anyone familiar with this printer and/or suggest somewhere I might get some support (HP stopped supporting it a long time ago).

Re: Help with HP Printer

PostPosted: Mon Aug 06, 2018 10:19 am
by eleciawilson88