(German) Newbie Freedom 360 Explorer Stitching gone very Bad

[SphereWorld]

(German) Newbie Freedom 360 Explorer Stitching gone very Bad

by SphereWorld » Mon Jul 04, 2016 7:41 pm

Hello,

i need a little bit help.
Sry my English is not so good. I try to explain.

I have an Freedom 360 Explorer Rig with 6x GoPro Hero 4 Black.
My Settings are the same at this Forum here. (1440p 48 fps)

I have a massive Problem with AVP to Stitch the Videos.
I make my synch with Clap.
Here i take a Photo of the stitch, there you can see 4 Papers with Zebra design Selfmade.

I do not know what I'm doing wrong. Please Help me, I am despairing.

[junct9]

Re: (German) Newbie Freedom 360 Explorer Stitching gone very

by junct9 » Mon Jul 04, 2016 10:47 pm

The Zebra pattern is possibly too close to the cameras, I've never been able to get a good stitch if objects are too close to the camera rig.

It's a nice idea you have there to calibrate a stitch with some kind of test card.

I'll let someone more expert answer this.

[SphereWorld]

Re: (German) Newbie Freedom 360 Explorer Stitching gone very

by SphereWorld » Wed Jul 06, 2016 5:57 pm

Please can someone help me?

[Amidee]

Re: (German) Newbie Freedom 360 Explorer Stitching gone very

by Amidee » Wed Jul 06, 2016 11:43 pm

definitely too close - minimum distance is 2 meters with that kind of rig!

[SphereWorld]

Re: (German) Newbie Freedom 360 Explorer Stitching gone very

by SphereWorld » Fri Jul 08, 2016 8:43 am

Cause i will make Videos indoor with a walking Person. I have Too many parallax effects. Is the omni Version better for the distance?

[Amidee]

Re: (German) Newbie Freedom 360 Explorer Stitching gone very

by Amidee » Fri Jul 08, 2016 9:07 am

Nope
The 10 GoPro rig allows for tighter stitches
Also there are the back to back setups with just two cameras with fisheye lenses, but quality takes a hit