Page 1 of 1

Using Pano template H3Pro7

PostPosted: Fri May 30, 2014 10:54 pm
by panojohn
When using template AutopanoVideo_360Heros_H3Pro7_Template.zip creating a reference panorama two camera views are incorrect. Both cameraviews 1 and 7 are in the right position (top/bottom) but reverse. So after rendering they play their part in reverse.

How to fix?

Re: Using Pano template H3Pro7

PostPosted: Fri Jun 06, 2014 10:57 am
by panojohn
Why does nobody from support react on this post?

Re: Using Pano template H3Pro7

PostPosted: Mon Jun 16, 2014 10:29 pm
by captain3d
Hi

I am just an end user like yourself. I found templates did not help me much but learning how to stitch videos from scratch really taught me a lot and I realized that templates are not really needed now. Sorry I cant help specifically.

Why not try the move tool in individual picture mode to put them in roughly the correct place then restitch. Then save a new template for yourself.

phil

Re: Using Pano template H3Pro7

PostPosted: Tue Jun 17, 2014 8:21 am
by Lionel Laissus
Hi

Could you tell me which template do you use and which version of AVP and APG ?

What do you mean by reverse ? Send me a screenshot .. thx

I created the templates with holder 1 "up" and holder 7 "down" .