Page 1 of 1

Video workflow case 2...

PostPosted: Sat Dec 28, 2013 7:07 pm
by gkaefer
in the newest Video workflow case
( http://www.autopano.net/wiki-en/action/ ... low_case_2 )
you do state:
This tutorial shows how to merge videos and still images together to get a perfect 360 video without any parallax.


if you do look at the docu screenshots you see perfect Images, perfect Nadir, no parallax, no Errors...
but if you do look at the final Video you do see them.... may it be the case you used a Video from earlier production stage?
Georg

Re: Video workflow case 2...

PostPosted: Sat Dec 28, 2013 7:08 pm
by gkaefer
two more screenshots...

Re: Video workflow case 2...

PostPosted: Mon Dec 30, 2013 11:43 am
by AlexandreJ
Hi Georg,

Yes, you are right. We didn't cleaned that sample that was presented during one slot at IVRPA 2013 in Island.
It is not our content, just an illustration that you can do 360° video without gopro, but by using standard dslr and be at the nodal point.
Which is quite nice in fact.

Nevertheless, it should be perfect and is not yet. Typically because detection and distortion correction has to be better. Which is the case with APG 3.5. I didn't check this case with the new engine, but it should match perfectly.