Page 1 of 1

Manual exposure compensation states after auto exposure

PostPosted: Sat Nov 14, 2015 6:40 am
by pana2000
Hi

Just getting used to the newer and excellent additions to the APV

Had no issues with adding manual stabilization points ( states ) When I tried exposure it was a bit harder

Re exposure
As per instructions ran auto exposure correction with in out sequence selected

Over the period of the 90 second clip there is still some exposure fluctuation between the start middle and end of the clip that I would like to tweak gradually over time

I have been able to apply manual adjustment points on the timeline but having trouble dragging that manual transition in the exposure timeline as is done in the stabilization Should say after the auto exposure was run the whole timeline ( in excess of the in and out point ) is now one long green transition that was automatically generated

Can manual exposure transitions be added after auto exposure correction has been calculated ?

If so how is this done

Should also say the auto exposure needs to be retained in the clip as it compensates for the variation in individual camera exposure That bit went fine Just need to adjust the overall exposure slightly over the whole clip

Thanks Lloyd

Re: Manual exposure compensation states after auto exposure  [SOLVED]

PostPosted: Mon Nov 16, 2015 3:50 pm
by martin.arnoux
Hi,

Auto-correction and manual correction aren't compatible in AVP. The only thing you can play with is the exposure slider for the entire panorama, after a correction.

Martin

Re: Manual exposure compensation states after auto exposure

PostPosted: Mon Nov 16, 2015 9:15 pm
by pana2000
Hi Martin

That explains it

Thanks kindly Lloyd

Ps I should have posted this another week thanks for getting back