Gund wrote:Hello again,
I'm using PTP 1.6
to made a video tour like this one http://bamboo.tomsk.ru/tour/?id=1
I have a 360-120 pano image and 3 .flv video files with alpha-channel.
Using spherical projection and normal view I got the following result http://360tomsk.ru/Panda/tour.html
It has sufficient quality and if I work more on the adjustment of rectangular video I can make it more neat.
However, when I change the projection to planar (like in the first link) the video is not displayed - so the question is - is it possible to put a rectangular video on a panorama in planar projection
And the second question - is it possible to cycle planar projection (like in the tour from the first link) ? So far when I build a tour with a planar projection panorama when I move left or rigth it eventually come to the edge of pano image and stops instead of cycling
I misused the terms - yes the pano was actually equirectangular 360-180 (later it was cropped to apprx. 120 )
I was talking about the projection of this equirectangular image in the final .swf project. It is probably called plane projection in English not planar.
I'd better use two examples
In the 1st tour the output projection is spherical while in the 2nd one planar
It is exactly the same project - only output projection is different.
So the question is - why reclangular video is ok in the 1st link and why it is invisible in the 2nd
The 2nd question - when you got to the edge of a pano in the 1st link it is cycled (you can infinitely rotate it right or left) but the one in the 2nd link is limited - when you got to the left or right edge - it stops and you have to get back
Gund wrote:Detiny told that planar projection is not designed to be cycled (http://bamboo.tomsk.ru/tour/?id=1 - this link where it is cycled was probably done in Adobe Flash or some other software)
I just want to ask - is it possible to edit xml in order to cycle planar projection of 360 panorama or such option is not supported and other software should be used to build a tour like on the link above.
Gund wrote:I've decided to work on the classic spherical output projection so far.
As I understand it is impossible to cycle the view when the output projection is set to planar.
Users browsing this forum: No registered users and 3 guests