Panosaurus clip-on mod  

In the panorama field, hardware is also part of the success. You can discuss here about it: camera, computer, pano head, anything
User avatar
DrSlony
Moderator
 
Topic author
Posts: 1893
Likes: 0 post
Liked in: 0 post
Joined: Sat Nov 03, 2007 6:30 pm
Location: Sweden
Info

Panosaurus clip-on mod

by DrSlony » Fri May 01, 2009 3:55 pm

Hey

Has anyone had any luck with modding the Panosaurus to enable clipping the camera into place instead of having to use the screws?

no avatar
hankkarl
Member
 
Posts: 1284
Likes: 0 post
Liked in: 0 post
Joined: Tue Feb 21, 2006 5:32 pm
Location: Connecticut, USA
Info

by hankkarl » Fri May 01, 2009 5:09 pm

I use a Manfrotto 303SPH and replaced the rail closest to the camera with a quick release system http://www.bhphotovideo.com/c/product/269979-REG/Manfrotto_by_Bogen_Imaging_625_625_Quick_Release_Adapter.html It looks big, but its lightweight.

I used this plate instead of the included one: http://www.bhphotovideo.com/c/product/554223-REG/Manfrotto_by_Bogen_Imaging_030ARCH_14_030ARCH_14_Architectural_Quick_Release.html

Note that the alignment issue is alignment along the "bottom" of the adapter plate--if the plate rotates, it means that your camera is tilted a degree or so up or down. (i.e. your pitch is not 0 degrees). This shouldn't affect your pano too much. Likewise, roll and yaw are not important. But the center of the plate has to be in exactly the same place all the time, or your "fore and aft" and "up and down" positioning becomes random. This quick release system seemed to be the best as far as repeatability goes. And it matches the QR system on my other tripod.
Last edited by hankkarl on Fri May 01, 2009 5:10 pm, edited 1 time in total.


Who is online

Users browsing this forum: No registered users and 1 guest