Page 1 of 1

Link Delight Pano Head

PostPosted: Wed Feb 09, 2011 11:46 pm
by BobF
Anybody using the Link Delight Pano Head? I've bought other things from them in the past and been quite happy with them. A pano head is a bit more complex piece of kit so wondering if anyone else has tried it. Like a lot of the stuff they sell, it appears to be a take off on the Manfrotto version.


PostPosted: Thu Feb 10, 2011 12:20 am
by mediavets
It doesn't look to me that you could adjust this head to set the camera/lens at the NPP.

PostPosted: Thu Feb 10, 2011 1:05 am
by BobF
I think you can, but am not positive. I believe the plates slide back and forth to allow for that type of adjustment. I've got a question in to them to confirm.

PostPosted: Thu Feb 10, 2011 1:56 am
by gkaefer
If I look at the comparison image I doubt that this is possible... perhaps only for pocket cams...
and in general spherical panos are done in portrait mode. So you would need extras to achiev that and so the NPP is far more away...

Liebe Gruesse,

PostPosted: Thu Feb 10, 2011 2:36 am
by BobF
Did you open the link to the additional images, Georg? In one of those images, it appears that the camera can go into portrait (vertical) orientation. This too is a question I've posed to the folks at Link Delight.

PostPosted: Sun Feb 13, 2011 3:20 am
by hankkarl
I see the left/right and up/down adjustments, but not a fore/aft one.