Greetings,

I have been doing some indoor 360 testing on some rooms in my house and so far all the results have come out fine, with the exception of the one in the pic below, I think I have narrowed it down to whether the lights were on or off in this particular room!

I have shot other rooms with the lights on and they have turned out ok so my only thought is that the artificial light on the wall was mixing with the natural light from outside?? thus causing problems in stitching, I tried so many variations of this room, and always with the same result, until I did one without the lights on, is this the reason that autopano is having problems with that one point in the picture,

It isn't too much of an issue as I can manually place the missing image but I would like to know so as to have a better understanding of shooting indoor 360's

kind regards