I did use the images attached in this posting
http://www.kolor.com/forum/p108394-yest … 41#p108394
and found following bug:

if images does not have EXIF data and you do set them in the image properties finalizing with pressing OK button, the values are accepted and than pano correct detected. in the Group window the values are displayed too.
+ but if you do enter the image properties again - the values are gone.
+ if you save the apg workpsace and later do reload them, than in the Group window "No exif information" is displayed.

Liebe Gruesse,
Georg

EDIT: PS: other vlaues like Detection image quality value (standard, High etc...) are also not saved with the apg workspace...

Last edited by gkaefer (2012-12-09 00:49:02)