since apg 3.0 (alpha1 - RC1) I observe following:

steps to reproduce:
+ openning a .pano file created with an apg 3.x version
+ going to edit mode
+ than using A) Preview button or B) Fusion button to display the "Blend Settings" Info block:
+ here in my case after opening the file the Level is showing 10 and it is in middle position.
+ if I move the setting now one value to the right it changes from 10 to 1.
+ if I now move it back 1 step to the middle position it changes from 1 to 0.

now 2 possible scenairos:
0 is the correct value so opening the file should show 0 instead of 10
or
10 is the correct value so opening the file should show on far right position at the 10

I've no idea if this has any impact on the pano or if this is only a cosmetic bug or if I just dont understand the logic.

Liebe Gruesse,
Georg

Last edited by gkaefer (2012-11-16 12:50:11)