The CPE is having some erratic behaviors during the optimization process. - First, you may encounter odds situations when some points are added, then running the optimization; the program can delete the bad and also good existing points. - Let's say that in the previous case you have a fisheye panorama and you didn't know about the optimization settings; once the settings were adjusted, the points are "properly" detected, however the panorama, would have a worst stitching quality. - If you run the geometric analysis the panorama would be totally destroyed and you will not be able to manually add more points (trying to fix the mess) - I found old behavior in this version; if you press optimize, then good CP start coming wrong, there is nothing that you can you do; close APG and start with the previous saved version - Important: the changes in the CPE does not trigger the panorama modification until you optimize the panorama, and you can close the panorama without warning of the changes made (and of course everything can be lost)
This is my first hand with the Alpha version and I'm not sure if these behaviors were already reported.